Products

NVC-H

- A vertical lifting clamp for steel plates and various steel blocks.

· Features

- The NVC-H has the built-in safety latch that prevents a work piece from slipping due to the initial clamping force caused

  by the spring even if the wire rope becomes loose during the operation.

· How to use

- Insert a steel plate into the inside end of the clamp's jaw opening and then lock the safety latch.

- Clamp the center of gravity of the work piece in order to equally distribute the weight of the work piece.

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual.

- Never lift two or more work pieces with one clamp.

- Lift a work piece only after checking the biting location and the biting condition of the work piece, and the proper

  functioning of the safety latch.

- When lifting a work piece, a signal man must be outside the rotation radius of a work piece to send a signal to a crane

  operator.