Products

NPC-Z

· Application

- A screw clamp for hanging the hook of a lever block when building vessels and manufacturing(attaching) construction

  plants.

· Features

- The NPC-Z is a screw clamp used to prevent accidents caused by the widening, slipping or breakage of the hook

   because the load is concentrated at the end of the hook when hanging the hook of a lever block and a chain block

   directly on a work piece.

- The NPC-Z is an efficient clamp that can improve the safety and the productivity of a worker due to the screw. This

   screw is located next to the eye hole in the upper part of the clamp in order to make it convenient to bite upper and

   lower work pieces when working in the middle of the block.

- The NPC-Z is a safe clamp designed to prevent a work piece from slipping as the jaw opening of the clamp gets smaller

  by the slope which is proportional to the load on the spherical swivel jaw built in the jig bearing which works as gearing

  on the opposite side of the screw.

· How to use

- Insert a work piece into the inside end of the clamp's jaw opening and then completely tighten the screw.

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual.

- If the load is placed laterally, not straightly, on the eye hole, use only 1/2 of the rated capacity.

- Never lift a work piece with this model.