Products

NPC-DC

· Application

- A T-section only screw clamp to transport or carry T-sections used for shipbuilding and plants.

· Features

- Rather than for hanging the hook of a lever block used to manufacture steel blocks, the NPC-DC is designed to be

  suitable for transporting T-sections.

- The NPC-DC is a convenient and efficient clamp with the shackle which rotates 360° right and left, making work

  possible in all directions(up and down, left and right). When clamping T-sections, depending on the angle of the wire

  rope(or chain), the shackle rotates to align with the rope, making this model convenient and efficient.

- The NPC-DC is a safe clamp designed to prevent a work piece from slipping as the jaw opening of the clamp gets

  smaller by the slope which is proportional to the load on the spherical swivel jaw built in the jig bearing which works as

  gearing on the opposite side of the screw.

· How to use

- Insert a work piece into the inside end of the clamp's jaw opening and then completely tighten the screw.

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual. 

- If the load is placed laterally, not straightly, on the shackle, use only 1/2 of the rated capacity.

- For horizontal lifting, the clamping point must be two or more. When clamping, the clamps must face each other, not

  look in one direction.