Products

NPC-LA

· Application

- A screw clamp for hanging the hook of a lever block which is used with nonferrous metal materials(stainless steel and

  aluminum) for building LNG tanks, other chemical tanks and plants which require no teeth mark left by clamps.

· Features

- To make it easy to clamp the end part of a work piece, the depth of the jaw opening in the NPC-LA is designed to be

   short.

- For the NPC-LA, on the upper and lower sides of the jaw opening are the flat surface swivel jaws with no tooth, and the

   special bearing is built in the NPC-LA so that the body rotates on the screw as the axis, making this model convenient

   to use.

- The synthetic resin pad which is attached to the inside of the jaw opening minimizes marks caused by clamping work

  pieces.

· How to use

- Insert a work piece into the inside end of the clamp's jaw opening and then completely tighten the screw.

· Warnings

- Before clamping, remove oil or grease on a work piece with detergent and a cloth to prevent slipping.

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual.

- If the load is placed laterally, not straightly, on the eye hole, use only 1/2 of the rated capacity.

- Never lift a work piece with this model.