Products

NPC-WB

· Application

- A clamp to pull a variety of steel work pieces when building ships and manufacturing (attaching) construction plants.

- When rotating boards and blocks vertically and 180°, the NPC-WB, a screw locking turnover clamp, can be used instead

  of the NVC-LPS, a turnover clamp.

· Features

- The location of the eye hole makes the NPC-WB convenient to vertically lift a work piece. The NPC-WB is a safe clamp

   designed to prevent a work piece from slipping. 

- The NPC-WB is a safe clamp designed to prevent a work piece from slipping as the jaw opening of the clamp gets

   smaller by the slope which is proportional to the load on the spherical swivel jaw built in the jig bearing which works as

   gearing on the opposite side of the screw.

· How to use

- Insert a work piece into the inside end of the clamp's jaw opening and then completely tighten the screw.

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use work pieces only which fall within the jaw opening range specified in  the instruction manual.

- Keep the lifting angle of a sling chain vertical (90°) to the ground For vertical lifting, the clamping points  must be two

  or more.