Products

NPC-FJ / NPC-FS

· Application

- A screw-locking clamp for hanging the hook of a lever block when building vessels and manufacturing(attaching)

  construction plants.

· Features

- The NPC-FJ and the NPC-FS are clamps used to prevent accidents caused by the widening, slipping or breakage of the

   hook because the load is concentrated at the end of the hook when hanging the hook of a lever block and a chain

   block directly on a work piece(bulb plate).

- The NPC-FJ has the jaw opening specially designed for bulb plates which are used as the frame of the outer plating and

   the inner plating in shipbuilding. It is a safe and convenient clamp that can do orizontal lifting due to the swivel jaw at

   the opposite side of the screw.

- The NPC-FS is a clamp designed to use with the wide flange of the angle.

· How to use

- Insert the bulb of a bulb plate or the flange of an angle into the clamp's jaw opening and then completely tighten the

  screw.

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual.

- Never use other materials except bulb plates with the NPC-FJ.

- If the load is placed laterally, not straightly, on the eye hole, use only 1/2 of the rated capacity

- Never lift work pieces with NPC-FS.