Products

NPC-H

· Application

- A screw locking clamp to be used instead of the hook of a lever block when building vessels and manufacturing

  (attaching) construction plants.

· Features

- The NPC-H is a screw clamp used to prevent accidents caused by the widening, slipping or breakage of the hook

  because the load is concentrated at the end of the hook when hanging the hook of a lever block and a chain block

  directly on a work piece.

- The NPC-H is a clamp to be used where the working place is too small to connect a lever block and a screw clamp. This

  model is an efficient clamp that can be used in place of the bottom hook of a lever block.

· How to use

- Insert a work piece into the inside end of the clamp's jaw opening and then completely tighten the screw.

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual.

- If the load is placed laterally, not straightly, on the U-shackle, use only 1/2 of the rated capacity.

- Never lift a work piece with this model.