Products

NWH-A / NWH-B

· Application

- A screw clamp for hanging the hook of a lever block which is used with metals such as special alloy steel and

   nonferrous metals (stainless steel, aluminum) for building LNG tanks, other chemical tanks and plants which require no

   teeth mark left by clamps.

· Features

- The MWH-A is a special clamp used to vertically erect a work piece which lies on the ground.

- Unlike other clamps, the MWH-A does not have a swivel jaw and the end part of the screw has no tooth. When

   vertically erecting a work piece, clamp the top part of the work piece with the NWH-B and the bottom part with the

   NWH-A.

· How to use

- Insert a work piece into the inside end of the clamp's jaw opening and then completely tighten the screw.

- When lifting, a balance beam must be used and the clamping points must be 2 or more.

   (1 point: NWH-A + NWH+B= 1 set)

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual.

- The angle of the wire rope must be vertical.