Products

NPC-SR

· Application

- A conveyor clamp used to clamp and then pull the work pieces when transporting work pieces by conveyors in the

  panel and small part assembly shops of shipyards.

· Features

- The NPC-SR has the hole in the back of the jaw opening for connecting a shackle, which is suitable to pull work pieces.

  On the opposite side of the screw is the planar swivel jaw which works as gearing to safely pull work pieces. 

· How to use

- Insert a work piece into the inside end of the clamp's jaw opening and then completely tighten the screw.

· Warnings

- Do not exceed the rated capacity specified on the clamp.

- Use a work piece only which falls within the jaw opening range specified in the instruction manual.

- As the screw and the jaw of the NPC-SR are easily worn out due to the concentrated load on the side, always check the

  abrasion of the clamp before use.

- Do not lift work pieces with this model.