· Application
- A ratchet press used instead of a jig when attaching L- and T-sections (frames) to the outer plating, the inner plating and the deck of a
ship.
· Features
- A ratchet press designed to be suitable for attaching another frame by hanging the NPP-A on the already welded low frame.
- The NPP-A is designed not to be pushed due to the swivel jaw assembled to the end part of the screw when operating the handle.
- The NPP-A can be customized according to the width and height of section steel.
· How to use
- After inserting the press jaw opening into the end part of the section steel flange, push up or down the pawl according to purposes and
then operate the handle.
· Warnings
- Do not exceed the rated capacity specified on the ratchet press.
- Use a work piece only which falls within the working length range specified in the instruction manual.
- Before use, always check the rotating condition of the jaw and the screw, and the grease injection condition.
- Store the NPP-A in a dry place with no water or moisture to prevent it from being rusty.
PREV | 이전글이 없습니다. |
---|---|
NEXT | NPP-B / NPP-C |