Products

NPP-B / NPP-C

· Application

  - Ratchet presses used instead of a jig when attaching L- and T-sections (frame) to the outer plating, the inner plating and the deck of a

    ship.

· Features

  - The NPP-B is designed to be suitable for attaching another frame by hanging the NPP-B on the already welded low frame.

  - The NPP-C is an efficient press which has two jaw openings (top and bottom) to enable the NPP-C to use with low and high frames (L-

    and T- sections).

  - The NPP-B and the NPP-C are designed not to be pushed due to the swivel jaw assembled to the end part of the screw when operating

    the handle.

  - The width and the length of the NPP-B and the NPP-C can be customized according to purposes.

· How to use

  - After inserting the jaw opening of the press into the end part of the section steel flange, completely tighten the fixing bolt.

  - Then push up or down the pawl according to purposes and operate the handle.

· Warnings

  - Do not exceed the rated capacity specified on the ratchet press.

  - Before use, always check the rotating condition of the pad and the shaft screw, and the grease injection condition.

  - Store the NPP-A in a dry place with no water or moisture to prevent it from being rusty.