Products

NH-TB / NH-TC

· Application

- Hooks for hanging the hooks of a lever block when building vessels and manufacturing(attaching) construction plants.

· Features

- The NH-TB and the NH-TC are designed to use with T-sections whose flanges are too narrow to work with a screw

  clamp.

- The NH-TB has no teeth on the shackle so that it leaves no teeth marks on a work piece.

· How to use

- For the NH-TB, have the hook clamp one flange of a T-section and then hang a lever block on the shackle.

- For the NH-TC, have the hook clamp both flanges of a T-section and then operate a lever block. 

· Warnings

- Do not exceed the rated capacity specified on the hook.

- Always use a work piece which falls into the working thickness range specified in the instruction manual.

- For the NH-TB, when having the hook bite a work piece, the direction must be the same as the direction of pulling the

  shackle.

- For the NH-TC, the shackle of the hook and the hook of a lever block must be vertical and then begin the work.

- Slowly operate a lever block so that the hook does not slip.

- Do not lift work pieces with the NH-TB and the NH-TC.